Morgan Advanced Materials announces availability of FireMaster® DryerWrap

Morgan Advanced Materials announces the availability of FireMaster® DryerWrap, a viable and cost effective solution for safely routing dryer exhausts from the laundry room to the building exit that results in significant installation cost and space savings

Morgan Advanced Materials announces the availability of FireMaster® DryerWrap, a viable and cost effective solution for safely routing dryer exhausts from the laundry room to the building exit that results in significant installation cost and space savings. Thinner, lighter, and noticeably more flexible than alternative fire wraps currently in the marketplace, FireMaster DryerWrap is ideal for application on dryer vent ductwork in multi-family residential units to meet fire compartmentalization and life safety requirements.


FireMaster DryerWrap is tested and UL-listed for 1-hour fire resistance on light gage construction up to 7-inch diameter or 10x4 inch rectangular duct-penetrating 1-hour rated wood joist gypsum floor. The material is fully encapsulated in scrim-reinforced foil (FSP). Installation is undertaken using 16-gage galvanized steel tie-wire.

At 1-inch thick and 6-pound per cubic foot density, the approved 1-inch compression or overlap joints allows for installation inside a 6-inch space. Despite its thin and lightweight form, FireMaster DryerWrap high temperature insulation is rated for 2100°F continuous exposure and has been fully tested on specifications typical of dryer and domestic kitchen range vent construction.

Featured Product

TRA SNOW AND SUN - SOLAR TILE MOUNT

TRA SNOW AND SUN - SOLAR TILE MOUNT

You haven't installed a tile mount that is easier to install than the Solar Tile Mount manufactured by TRA Snow and Sun. Solar Tile Mount is used on all tile roof profiles: flat, mid, and high. It is made in the USA of aluminum alloy for strength and excellent corrosion resistance. Solar Tile Mount is built to allow more ease in installation with more rise from the tile surface to the rail for better air flow below panels. The adjustable base is longer than most allowing attachment 6" to the left or right to have the bracket in the base of the pan of the tile and still fasten to the rafter. Solar Tile Mount is adjustable for counter batten systems from ¾" to 3". The horizontal rail is directly above base fasteners giving greater uplift resistance than any other system. For superior waterproofing apply TRA Snow and Sun's butyl backed VersaFlash aluminum flashing. No tile flashing is needed on top of the tile for greater labor and material cost savings.