Siemens to supply offshore wind turbines to world´s largest floating wind farm

• 30 MW “Hywind Scotland” project with five Siemens turbines of Six-Megawatt-class • Collaboration on floating wind turbines started in 2009

Siemens is strengthening its collaboration with Norwegian company Statoil on floating offshore wind turbines. For the 30 megawatt (MW) Hywind Scotland Project, Siemens will supply five of its SWT-6.0-154 direct drive offshore wind turbines. The turbines will be installed on floating foundations operating in water depths between 90 and 120 meters. The world's largest floating wind project is located in Scottish waters 25 kilometers off the coast of Peterhead in Aberdeenshire. For the new Hywind Scotland Project, assembly in West Coast Norway is scheduled for first half 2017. In 2009 Statoil and Siemens successfully installed a 2.3 MW Siemens turbine at the first floating full-scale wind project worldwide, Hywind Demo.


This Scottish pilot project demonstrates how future floating concepts for commercial and large scale offshore wind parks can be both cost efficient and low risk. The floating foundations are ballast-stabilized and fastened to the seabed with mooring lines. With their lightweight nacelles, Siemens large direct drive wind turbines are particularly suited for the floating foundations designed as slender cylinder structures. This concept has already proven its effectiveness in the 2009 project. At the same time Siemens gathered a lot of experience on the specific requirements regarding the control parameters on a moving wind turbine under offshore conditions. For the floating installation Siemens' technicians developed new controller settings for rotor pitch and yaw drive regulation.

"We are proud to once again be on board the floating wind project with Statoil, and to apply the experience we gained with the first full scale floater," said Morten Rasmussen, Head of Technology at Siemens Wind Power and Renewables Division. "Hywind Scotland is another pioneering project and has the potential to become a trailblazer for future floating wind projects."

This press release and a press picture and the infographic are available at: www.siemens.com/press/PR2015120105WPEN

For further information on Division Wind Power and Renewables, please see:www.siemens.com/wind

Featured Product

The Solar Fastener Expert by Mudge Fasteners. Your Source for Solar Industry-Related Hardware

The Solar Fastener Expert by Mudge Fasteners. Your Source for Solar Industry-Related Hardware

3M™ Extreme Sealing Tape is a family of single coated, pressure sensitive adhesive tapes designed for difficult sealing applications. The backing on this tape is an ionomer film that is very tough yet flexible and abrasion resistant. The very soft and thick acrylic adhesive has excellent sealing properties and good outdoor durability. This single coated tape is designed to seal over an existing joint, seam, or penetration. The adhesive is designed to adhere well to the ionomer film so that overlapping tape joints can be made while maintaining a strong seal. 3M™ Extreme Sealing Tape - instant sealing that rolls on fast and looks good.