OMG PowerGrip for Solar Rack Systems Featured at SPI - Booth 2377

OMG Roofing Products to Display PowerGrip for Solar Panel Attachment At Solar Power International Show – Booth 2377

AGAWAM, Mass., July, 2012 – OMG Roofing Products will showcase its new PowerGrip roof mount system for securing rooftop solar racks and other equipment to thermoplastic (TPO and PVC) roofing membranes at Solar Power International, Sept. 10-13 at the Orange County Convention Center, Orlando, Fla., Booth 2377.


PowerGrip provides a secure connection directly to the roof deck or structural members. Once secured and heat welded in place, properly installed PowerGrips virtually eliminate rack movement and remain watertight.

Factory fabricated OMG PowerGrip assemblies are easy-to-install and can be made with any TPO or PVC membrane on the market, for 100% compatibility with the specific roofing system. Moreover, PowerGrips are compatible with most types of solar racking systems currently on the market and do not require any field fabrication or assembly. In addition, since they eliminate the need to cut open the roof down to the deck, the system saves time and labor. PowerGrips may also be used with ballasted racking systems potentially reducing the amount of ballast required, so there's less weight on the roof.

Each PowerGrip features a nine-inch wide diameter welding flange and a -in. tall weather resistant aluminum perch. An exposed 1-in. tall x 3/8-in. diameter stainless steel bolt provides a secure connection point for solar racks and other roof-top equipment.

OMG PowerGrip is fully compatible with all TPO and PVC membranes and can be used on mechanically attached, fully adhered and ballasted roofing systems.

In addition to solar racks and mounts, OMG PowerGrip can be used in many other roof mounted applications, including: pipe supports and hangers, step crossovers, electrical conduit and raceways, TV dishes and small antenna, HVAC applications as well as sign and wind-screen supports, among others.

Contractors should always check with the roof system manufacturer for installation criteria and written acceptance of the intended application prior to installation. Failure to do so could void the roofing warranty. For structural applications, always consult a structural engineer for installation criteria prior to application.

PowerGrips are packaged 20 per carton and available through OMG's national distribution network. OMG Roofing Products is the North America's leading manufacturer and supplier of fasteners and other accessories used in low slope commercial roofing applications, and a proud member of SEPA. For additional information, contact your local OMG sales representative, call OMG customer service (800/633-3800) or visit www.olyfast.com.

# # #

Featured Product

TRA SNOW AND SUN - SOLAR TILE MOUNT

TRA SNOW AND SUN - SOLAR TILE MOUNT

You haven't installed a tile mount that is easier to install than the Solar Tile Mount manufactured by TRA Snow and Sun. Solar Tile Mount is used on all tile roof profiles: flat, mid, and high. It is made in the USA of aluminum alloy for strength and excellent corrosion resistance. Solar Tile Mount is built to allow more ease in installation with more rise from the tile surface to the rail for better air flow below panels. The adjustable base is longer than most allowing attachment 6" to the left or right to have the bracket in the base of the pan of the tile and still fasten to the rafter. Solar Tile Mount is adjustable for counter batten systems from ¾" to 3". The horizontal rail is directly above base fasteners giving greater uplift resistance than any other system. For superior waterproofing apply TRA Snow and Sun's butyl backed VersaFlash aluminum flashing. No tile flashing is needed on top of the tile for greater labor and material cost savings.