Big Data – applied analytics enhances O&M programmes

Owner/Operators and Investors are scrutinising Wind O&M programmes like never before. The maturity of wind energy in the generation mix specifically means that there is now the impetus to reflect on past industry performance and learn from operational experiences over the last 25 years.

As further accuracy and enhancements are made in wind prediction and measurement, and regulatory regimes showing potential signs of stability (particularly in the US following the renewal of the Production Tax Credit) so the attention now turns from the top line to the bottom line as project stakeholders seek to increase yields and reduce cost. While these two variables would seem to be in conflict, a carefully constructed O&M programme can achieve precisely that by proactive measures that will increase yield through lower downtime, achieved at a potentially lower cost.


In order to construct and craft an effective O&M programme, an in depth knowledge of the plant is required – including service intervals, spares inventory, access to labour, crane hire agreement, access restrictions etc. Typically, there is a reliance on the engineering expertise that resides at owner or project level, leveraging on the experience of the engineers who have managed and worked on Wind Turbines for many years, in some cases since the dawn of the industry itself. While the input of project engineers is essential, the application of data analytics to O&M can assist in pinpointing loss drivers from a time and cost perspective. These outputs can then be used and applied by experienced engineers to reconfigure and optimise existing O&M programmes.

There is a huge amount of data now available from a Wind Energy Project, including (but not limited to):

• SCADA Data – whether in real time or reported out on a specific interval (e.g. 10 minutes) or change-only basis.
• CMS Data – whether from vibration monitoring, acoustic emissions or lube oil monitoring.
• Work Order Data – detailing where, when and how much each repair costs.
• Anemometer Data – extracted from the SCADA but processed separately.

Making sense of the vast quantities of data, which could be up to 1TB of data per week in raw unprocessed form, is an overly complex and time consuming task for manual analysis. The application of dedicated, sophisticated analytics to this data assists the engineer in making sense of the data and provides useable outputs to (re)configure O&M programmes.

To gain access to an exclusively produced whitepaper focussing on this topic, simply request your copy here: http://www.windenergyupdate.com/operations-maintenance/content.php

Or contact

Jon Harman
Wind Energy Update
+44 (0)207 375 7577
jon@windenergyupdate.com

Featured Product

RBI Solar - Dahlia Has You Covered

RBI Solar - Dahlia Has You Covered

What if you could maximize the Ground Coverage Ratio (GCR) on your next project and not have to worry about the complicated variables that come with a tracker system? With a low tilt and clearance design, Dahlia® has the highest GCR of any fixed-tilt system in the marketplace. The system is available in three tilt options (7.5, 10 and 12.5 degrees) and designed to accommodate any sized PV module. The lightweight system is engineered with fewer components, several of which are shipped to job sites pre-assembled. This design feature reduces freight costs and rapidly trims the amount of on-site installation time required to complete construction. Maximizing PV coverage on a site can lead to an increase of production, which creates greater financial return for project owners. Over 100 MW of Dahlia® projects have been deployed across the United States, in regions of variable snow and wind loads. How much can Dahlia® cover and save you on your next project?