Data from AMP and Ohio State shows that wind power in Ohio is a good deal for its customers, and that its price is competitive with, and in some cases significantly cheaper than, other sources of power.
By Eleanor Goldberg for The Huffington Post: While there are many technologies out there than can effectively remove salt from water to make it drinkable, most are expensive and rely heavily on electricity –- rendering them all but useless in remote, off-grid villages. That’s why a group of engineers from MIT, backed by Jain Irrigation Systems, set out to invent a system that relies on solar energy to bring clean drinking water to rural areas in India, The Washington Post reported. About 21 percent of India’s communicable diseases are related to unsafe water, according to the World Bank. According to MIT researchers 60 percent of India has brackish groundwater -- while not toxic, that water is too salty to be ideal for human consumption. The group, which took home the first-place Desal Prize last month in the “Securing Water for Food” challenge, used a method called electrodialysis, which relies on electricity and ultraviolet rays, according to the aid organization. The first-place winners were awarded a $140,000 grant. Cont'd...
While buying a solar panel one must keep in mind various factors like where it will be installed, purpose; commercial or residential use, and budget.
A road made of solar panel material is producing more energy than the creators expected. Engineers created a solar power bike path near Amsterdam that is over 200 feet long last year, and the road generated over 3,000kwh during the first six months, according to Al Jazeera, enough energy to power a house for a year. The company that created the road, SolaRoad, claims that means the road can produce 70kwh per square meter per year. The road is made of solar panels, glass, rubber and concrete. The road can either power street lamps or add power to the general grid. Over 150,000 cyclists have ridden on bike path without a problem since the project began. The path is made to be non-reflective and to prevent skidding. SolaRoad is still refining its materials to make them even more weather proof and efficient, and the company hopes to expand to larger areas in the future.
The installation involved locating where the fastener is going, driving the fastener into the metal deck underneath the insulation and membrane, sliding the PowerGrip over the fastener head, and hot air welding it in place.
Bill Tucker for Forbes: Vortex Bladeless is a radical company. It wants to completely change the way we get energy from the wind. Think wind stick instead of a massive tower with blades that capture blowing winds. Wind stick. Really. Lest you think I’m mad, I’ve included a picture of this bladeless generator that helps with the visualization and explains the company name. See? There are no blades. What that “stick” (the company prefers, mast) does is capitalize on an effect of the wind which has been a very serious problem for architects and engineers for decades. When wind hits a structure and flows over its surfaces the flow changes and generates a cyclical pattern of vortices at the tail end of the flow. This is known as the vortex shedding effect which creates something known as vorticity and that is what Vortex Bladeless uses to generate energy. For those who need a explanation that exceeds my ability to fully explain, check out this link on Wikipedia and then come back and join the rest of us who won’t wait for you. (you’re clearly ahead of us anyway)
It is important to pay attention to product specifications regarding the rate at which energy is coming in, the amount of energy stored, and the rate at which that energy is being consumed.
Adopting a building-integrated solar air heating system for a multi-residential, high rise exterior retrofit of the Lyndon B. Johnson public housing complex in Cambridge, Massachusetts.
From Melissa Abraham | MIT Energy Initiative : Report highlights enormous potential and discusses pathways toward affordable solar energy. Solar energy holds the best potential for meeting humanity’s future long-term energy needs while cutting greenhouse gas emissions — but to realize this potential will require increased emphasis on developing lower-cost technologies and more effective deployment policy, says a comprehensive new study, titled “ The Future of Solar Energy ,” released today by the MIT Energy Initiative (MITEI). “Our objective has been to assess solar energy’s current and potential competitive position and to identify changes in U.S. government policies that could more efficiently and effectively support its massive deployment over the long term, which we view as necessary,” says MITEI Director Robert Armstrong, the Chevron Professor in Chemical Engineering at MIT.
The system incorporates panels and micro-inverters and steel and bearings and a microcontroller with an LCD display, to control the daily motion of the array. And, I might add, a light sensor to sense night time and daytime, and an AC current sensor to measure the amps produced (by the array) and amps consumed by the controller.
Renewable Energy Corporation, a Baltimore solar panel installer, created the graphic below to show how Maryland and Virginia measure up against each other.
One of the fastest-growing areas of solar energy research is with materials called perovskites. These promising light harvesters could revolutionize the solar and electronics industries because they show potential to convert sunlight into electricity more efficiently and less expensively than today’s silicon-based semiconductors. These superefficient crystal structures have taken the scientific community by storm in the past few years because they can be processed very inexpensively and can be used in applications ranging from solar cells to light-emitting diodes (LEDs) found in phones and computer monitors. A new study published online April 30 in the journal Science by University of Washington and University of Oxford researchers demonstrates that perovskite materials, generally believed to be uniform in composition, actually contain flaws that can be engineered to improve solar devices even further. Cont'd...
1.7MW and 1.2MW installations will provide equivalent power for roughly 920 average households.
We have researchers here developing systems that should be able to convert more than 40% of the incoming sunlight to electricity (current panels are ~20% efficient). We are also working with research groups that can generate fuels and chemicals directly form sunlight, or from biomass, hopefully at an efficiency and cost that will replace conventional fossil fuel materials.
Offshore wind is coming to the United States. Construction on what will be the country’s first offshore wind farm started Monday in Rhode Island. The wind farm, which is being developed by Deepwater Wind, will be located off of the coast of Block Island, a small island about 13 miles south of Rhode Island. Once completed, the five-turbine, 30-megawatt wind farm will produce enough energy to power all homes and businesses on Block Island, which previously relied on diesel generators, according to the Sierra Club. The wind farm will also send energy to mainland Rhode Island. It’s expected to come online in fall 2016. Environmental groups, many of which have pushed for the project since it started going through hearings in 2013, applauded the start of construction. Bruce Nilles, senior campaign director for the Sierra Club’s Beyond Coal Campaign, told ThinkProgress that the start of construction was a “landmark” moment for the U.S. wind industry, and that it “really makes real the promise offshore wind has” in the U.S., particularly on the East Coast. “This is technology that will play a very important part in decarbonizing electric sector,” he said.
Records 796 to 810 of 3070
Solar & Wind - Featured Product
With Baja Carports 35 plus years in the industry installing our Solar Support Systems nationwide and whose founder Bob Hayworth was one of the first to use solar panels as the rooftops on commercial carports ~ is assurance that you will receive Baja expertise in all phases of installation. Our team's diligence makes the design-build process easy for customers. You don't need a set of architecture plans to begin talking to us about your project. Baja's in-house design engineers will work closely with you to meet your project specifications and city's criteria. You'll have our design team's years of experience applied to your plans. Our engineers will deliver a set of stamped plans, which maximize canopy coverage and details the most-effective layout for your business' parking lot.