Marathon Special Products launches PV Fuse Holder designed to terminate to standard bus bar
This pv fuse holder is uniquely designed with terminals to accept standard bus bar as opposed to fabricated custom bars. The ability to use standard bus bar enables system integrators to significantly reduce the amount of copper bar purchased, bus bar fabrication, engineering and assembly time.
BOWLING GREEN, OHIO – Marathon Special Products, a division of Regal Beloit Corporation, is proud to announce an addition to our line of fuse holders. This pv fuse holder is uniquely designed with terminals to accept standard bus bar as opposed to fabricated custom bars. The ability to use standard bus bar enables system integrators to significantly reduce the amount of copper bar purchased, bus bar fabrication, engineering and assembly time.
More Headlines
- OMCO Solar - Celebrating Project 100
- Powering the Future with AI: Sigenergy Showcases Smart Energy Breakthroughs at Intersolar Europe 2025
- EcoFlow Launches STREAM Series, the First U.S. Plug-and-Play Home Solar System Designed for Apartments and Condos in Addition to Single Family Homes
- REN21 LAUNCHES GROUNDBREAKING 'RENEWABLE ENERGY CHAMPIONS' INITIATIVE TO ACCELERATE THE SHIFT TO ENERGY-SECURE RENEWABLE-BASED ECONOMIES
- Intersolar 2025 - Kseng Solar Shines with All-Scenario Solar Solutions, Driving Energy Transition in Germany and Beyond
The PV10BW will have UL4248-18 conformance up to 1000 volts and 30 amps, with terminals evaluated for use with 90°C wire. This design allows it to run cooler than traditional designs. In addition to the fuse holder's natural bus bar enclosing design, side and end covers are available for additional protection.
For more information, please call 419-373-4213 or email marketing@marathonsp.com.
Featured Product
HPS EnduraCoilTM Cast Resin Medium Voltage Transformer
HPS EnduraCoil is a high-performance cast resin transformer designed for many demanding and diverse applications while minimizing both installation and maintenance costs. Coils are formed with mineral-filled epoxy, reinforced with fiberglass and cast to provide complete void-free resin impregnation throughout the entire insulation system. HPS EnduraCoil complies with the new NRCan 2019 and DOE 2016 efficiency regulations and is approved by both UL and CSA standards. It is also seismic qualified per IBC 2012/ASCE 7-10/CBC 2013. Cast resin transformers are self-extinguishing in the unlikely event of fire, environmentally friendly and offer greater resistance to short circuits. HPS also offers wide range of accessories for transformer protection and monitoring requirements.
